MORF PSU Mod Kit

The MORF PSU mod kit was designed to turn your ordinary power supply into a stylish "Oooohhhh" one. Multiple colors are available ranging from black, UV Red, UV Blue and UV Green. Each kit contains the following:

  • 4 types of Flex Sleeve sleeving
    • 1 3mm x 3.3m
    • 1 6mm x 3.3m
    • 1 10mm x 1.6m
    • 1 12mm x 1.6 m
  • 3 types of Shrinkz heatshrink
    • 1 10mm x 30cm
    • 1 20mm x 30cm
    • 1 25mm x 15cm
  • 10 x Tiewraps
  • 5 types of Connectx
    • 10 x 4 pin Molex female connector
    • 3 x floppy power female connector
    • 1 x ATX 20 pin female connector
    • 1 x P4 12V female connector
    • 1 x AUX 6 pin female connector
  • 2 types of Toolx
    • 1 x Toolx pin remover for Molex
    • 1 x Toolx pin remover for ATX/P4

They missed out on 2 small things in the kit. With the rising popularity of SATA, most power supplies are coming with SATA power connectors. As you may have noticed, A.C. Ryan didn't provide UV connectors for SATA power in the kit. Hopefully they'll make a correction soon.

The other thing they didn't provide was a manual on how to perform this mod. I know some of you may think it's fairly simple to do this, but for the first timers out there, a manual on how to properly do this mod would be very much appreciated.

Yanking out my power supply I set off on my trek to mod it. Here's the fruits of my labor after an hour:

Before

After an hour

It's not an easy job, especially for the ATX power conectors. Apparently less expensive PSU's are easier to mod than the more expensive ones as the fittings aren't as tight. The indestructible toolx pin remover for the ATX connector... well let's just say it's not indestructible. I made use of 2 really small sewing pins instead after the little mishap. This isn't one of the easiest mods to do and requires a lot of time and patience. A little experience wouldn't hurt either.